TWO COMPONENT HIGH BUILD EPOXY COATING
DESCRIPTION
MULTI POXY 1938 is an epoxy floor coating with high build thickness with good chemical resistant properties which gives a tough but resilient floor coating, with reasonable colour stability. A flooring system able to provide appeal in gloss and colour, display good all-round abrasion and scuff resistance. Available in a variety of colours.
TYPICAL APPLICATIONS
For use in commercial and industrial applications where high gloss and colour are required with seamless professional finishing. Used in car showrooms, offices, kitchens, laboratories, shopping areas, shop floors and domestic applications.
ADVANTAGES
- Good colour stability
- Long lasting
- Seamless flooring
- High gloss
- Easy application
- Superb aesthetic
- High resistance to water and chemicals
- Easy to maintain
TYPICAL PROPERTIES
Yield: 5L
Coverage: 25m²
Application Temperature: 10°C to 35 °C
Application Thickness: 250 – 300 micron
Pot Life: 20 minutes
Cure (Light Traffic): 24 hours
Full Cure: 7 days
Compressive Strength: 60MPa
Bond Strength: 1,5 N/mm2
WATCH POINTS
- Moisture content in the substrate must be below 12%.
- Colours must be from the same batch to reduce risk of colour variations.
- Exposure of the coating to intense lighting or direct sunlight will produce discolouration in time.
DIRECTIONS FOR USE
SURFACE PREPARATION
Surfaces to be clean, sound and free of deleterious substances. Remove all laitance, oil, grease, paints, mould oil or curing compound from concrete surfaces using wire brush, bush hammer, scabbler or other plant as appropriate. Ensure that the substrate is flat and smooth, repairing any holes and dips to level finish. Use MULTI SELF–LEVELING screed if required. Friable screeds will have to be removed or re-screeded as necessary. Note any joints in order to follow through the epoxy screed where necessary.
PRIMING
Use MULTI POXY PRIMER or an initial coat of MULTI POXY 1938 to prime all substrates prior to final application of MULTI POXY 1938.
APPLICATION
Using a festo mixer or other suitable mechanical mixer, mix the resin and hardener together in a clean bucket or metal drum. Pour out the entire contents over the primed areas and spread out with a mohair roller for 150–200 micron coatings or steel trowel for 250 and greater micron coatings and allow to settle. Allow 24 hours before light traffic.
EQUIPMENT CARE
All tools should be cleaned with thinners immediately after use. If delayed, equipment will need mechanical action to clean or be discarded.
PACKAGING
Supplied in 5L and 20L Kits, resin and hardener.
REVISION: v2019- R3
The information supplied is believed to be reliable. As we do not have any control over the processing or application of the product we cannot guarantee the results to be obtained.
Users assume all risks and liability resulting from the use of this product and must confirm suitability thereof by conducting their own tests.
No guarantee is expressed or implied. Liability to the replacement of faulty material.
FOR PROFESSIONAL USE ONLY.