General Purpose / Dowel Epoxy Adhesive
MULTI POXY 1304 is a high strength, thixotropic solvent free epoxy adhesive used to fill dowel holes and for use as a general epoxy adhesive. Sets at low temperatures and is resistant to moisture and has excellent chemical resistance.
Bonding of doweling rods in both vertical and horizontal applications. A general-purpose epoxy adhesive where a thick, drip free epoxy is required. Used to fill gaps and holes as a filler.
- Long pot life
- Drip free
- High compressive strength
- Excellent adhesion to concrete
- Moisture tolerant
- High resistance to water and chemicals
Appearance: Amber Paste
Application Temp: 10°C to 25 °C
Compressive Strength: >50MPa
Pot Life: 30 minutes
Initial set: 1-2 hours
Hard set: 8 hours
Practical Cure: 24 hours
Full Cure: 7 days
Ratio of hole to diameter of dowel: 1.25:1
Depth of Dowel: 7.5 x diameter of dowel rod
Bond Strength: 1,5 N/mm²
Cleaning: Soapy Water
- Exposure of the epoxy to intense lighting or direct sunlight will produce discolouration in time.
- Do not hold a full kit in a bucket for more than 5 minutes, rather work out onto the target areas and work within the working time of the product.
DIRECTIONS FOR USE
Surfaces to be clean, sound and free of deleterious substances. Remove all laitance, oil, grease, paints, mould oil or curing compound from surfaces using wire brush, bush hammer, scabbler or other plant as appropriate. Drilled holes are to be free of dust.
No priming is required.
Mix the resin and hardener together in a clean bucket. Mix only enough to be able to work out within the pot life of the epoxy. Trowel out using steel trowels or work into confined spaces. Bonded surfaces should be kept under compression until the epoxy has set hard. When grouting, fill from the base upwards to avoid formation of air pockets.
All tools should be cleaned with soapy water immediately after use. If delayed, equipment will need thinners or mechanical action to clean or be discarded.
Supplied in 1L, 2L, 5L and 20L two component kits.
Multi Construction Chemicals South Africa (PTY) Ltd production and testing programs comply with all local and international testing standards. MULTI EXPANSION TAPE jointing system shall be fastened in position to give continuous network with 100 mm minimum overlaps and installed in accordance with the manufacturer’s instructions.
The information supplied is believed to be reliable. As we do not have any control over the processing or application of the product we cannot guarantee the results to be obtained.
Users assume all risks and liability resulting from the use of this product and must confirm suitability thereof by conducting their own tests.
No guarantee is expressed or implied. Liability to the replacement of faulty material.
FOR PROFESSIONAL USE ONLY.