CRACK INJECTION EPOXY
MULTI POXY 1306 is a high strength, low viscosity pourable epoxy compound used to fill tight gaps and cracks in concrete. Sets at low temperatures and is resistant to moisture and has excellent chemical resistance.
Provides structural repairs to cracks and damaged concrete structures such as columns, beams, floors, and bridge decks. May be used as a casting and encapsulation compound.
- Low viscosity
- Long pot life
- High compressive strength
- Excellent adhesion to concrete
- Moisture tolerant
- High resistance to water and chemicals
Appearance: Clear amber liquid
Application Temp: 10°C to 25 °C
Compressive Strength: >50MPa
Pot Life: 30 minutes
Initial set: 1-2 hours
Practical Cure: 4-5 hours
Full Cure: 5 days
Chemical Resistance: Resists aggressive cleaning materials, acids, alkalis and water solutions
Bond Strength: 1,5 N/mm²
- Exposure of the epoxy to intense lighting or direct sunlight will produce discolouration in time.
- Do not hold a full kit in a bucket for more than 5 minutes, rather pour out onto the target areas and work within the working time of the product.
DIRECTIONS FOR USE
Surfaces to be clean, sound and free of deleterious substances. Remove all laitance, oil, grease, paints, mould oil or curing compound from surfaces using wire brush, bush hammer, scabbler or other plant as appropriate.
No priming is required.
Mix the resin and hardener together in a clean bucket. Mix only enough to be able to work out within the pot life of the epoxy. Trowel out using steel trowels, or pump into confined spaces. Allow 8 hours before applying pressure or loads on the repaired areas. Overcoat with any solvent free epoxy-based coating such as MULTI POXY 1938 in colour of choice within 12 hours to ensure good chemical bond with the coating.
All tools should be cleaned with thinners immediately after use. If delayed, equipment will need thinners or mechanical action to clean or be discarded.
Supplied in 1L, 2L, 5L and 20L two component kits.
Multi Construction Chemicals South Africa (PTY) Ltd production and testing programs comply with all local and international testing standards. MULTI EXPANSION TAPE jointing system shall be fastened in position to give continuous network with 100 mm minimum overlaps and installed in accordance with the manufacturer’s instructions.
The information supplied is believed to be reliable. As we do not have any control over the processing or application of the product we cannot guarantee the results to be obtained.
Users assume all risks and liability resulting from the use of this product and must confirm suitability thereof by conducting their own tests.
No guarantee is expressed or implied. Liability to the replacement of faulty material.
FOR PROFESSIONAL USE ONLY.