THREE COMPONENT 2MM EPOXY SCREED
MULTI POXY 1202 is an epoxy flooring screed at 2mm nominal thickness with good chemical resistant properties which gives a tough but resilient flooring system, with reasonable colour stability. Suitable for areas with excessive load bearing requirements.
For use in commercial and industrial applications where high gloss and colour are required with seamless professional finishing. Used in warehouses, wineries, breweries, hangers, factory floors, engineering workshops.
- Good colour stability
- Long lasting
- Seamless flooring
- High gloss
- Easy application
- Superb aesthetic
- High resistance to water and chemicals
- Easy to maintain
Yield: See Pack Size
Coverage: 0.5m2 per litre
Application Temp: 10°C to 25 °C
Application Thickness: 2mm Trowel on application
Pot Life: 20 minutes
Cure (Light Traffic): 24 hours
Full Cure: 7 days
Compressive Strength: 60MPa
Bond Strength: 1,5 N/mm2
- Substrates must be flat and smooth.
- Ensure good priming to avoid blow holes or pin holes.
- Spike rolling must be well done to release entrapped air.
- Dust contamination on the surface must be prevented during cure.
DIRECTIONS FOR USE
Surfaces to be clean, sound and free of deleterious substances. Remove all laitance, oil, grease, paints, mould oil or curing compound from concrete surfaces using wire brush, bush hammer, scabbler or other plant as appropriate. Ensure that the substrate is flat and smooth, repairing any holes and dips with MULTI FEATHER FINISH. Use MULTI SELF–LEVELING screed if the substrate surface needs to be levelled completely required. Friable screeds will have to be removed or re-screeded as necessary. Note any joints in order to follow through the epoxy screed where necessary.
MULTI POXY PRIMER or a scraper coat of MULTI POXY 1202 resin and hardener (no aggregate).
Using a festo mixer or other suitable mechanical mixer, mix the resin and hardener together in a clean bucket or metal drum. When mixed, add in the aggregate until a uniform, smooth mix is achieved. Pour out the entire contents over the primed areas and spread out with a steel trowel and allow to settle. Spike roll to remove bubbling and encourage levelling. Allow 24 hours before light traffic.
All tools should be cleaned with thinners immediately after use. If delayed, equipment will need mechanical action to clean or be discarded.
Supplied in 5L, 10L and 20L Kits
Multi Construction Chemicals South Africa (PTY) Ltd production and testing programs comply with all local and international testing standards. MULTI EXPANSION TAPE jointing system shall be fastened in position to give continuous network with 100 mm minimum overlaps and installed in accordance with the manufacturer’s instructions.
The information supplied is believed to be reliable. As we do not have any control over the processing or application of the product we cannot guarantee the results to be obtained.
Users assume all risks and liability resulting from the use of this product and must confirm suitability thereof by conducting their own tests.
No guarantee is expressed or implied. Liability to the replacement of faulty material.
FOR PROFESSIONAL USE ONLY.