DESCRIPTION

MULTI POXY 1309 is alinseed oil curedputty epoxy compound used to fill holes in porous or bitumen-based substrates. Used extensively as an adhesive where fast set cure is required e.g., road studs. 

TYPICAL APPLICATIONS

For commercial and industrial applications where high early strength and fast set onto surfaces such as tar, concrete and plaster is required.  

ADVANTAGES

• Putty consistency 
• Fast set 
• Economical 
• High compressive strength 
• Excellent adhesion to dry concrete 
• Non-shrink 
• High resistance to water and chemicals 

TYPICAL PROPERTIES

Appearance: Mid Grey Putty 
Application Temp: 10°C to 25°C 
Compressive Strength: >35MPa 
Pot Life: 20 minutes 
Initial set: 1 hour 
Practical Cure: 3-4 hours 
Full Cure: 7 days
Chemical Resistance: Resists aggressive cleaning materials, acids, alkalis and water solutions 
Density: 1,8 kg/L 
Cleaning: Thinners

WATCH POINTS

• Clean off epoxy from equipment while still in wet state. 
• Mix part A (light grey) and part B (black) until the colours are uniformly mixed to a mid-grey colour. 

DIRECTIONS FOR USE SURFACE PREPARATION

Surfaces to be clean, dry, sound, and free of deleterious substances. Remove all laitance, oil, grease, paints, mould oil or curing compound from surfaces using wire brush, bush hammer, scabbler or other plant as appropriate.  

PRIMING

No priming is required. 

APPLICATION

Mix the resin and hardener together in a clean bucket. Mix only enough to be able to work out within the pot life of the epoxy. Trowel out using steel trowels, or pump into confined spaces. Allow3-4 hours before applying pressure or loads on the treated areas.

EQUIPMENT CARE

All tools should be cleaned with thinners immediately after use. If delayed, equipment will need thinners or mechanical action to clean or be discarded. 

PACKAGING

Supplied in 1Ltwo component kits.  

QUALITY ASSURANCE

Multi Construction Chemicals South Africa (PTY) Ltd production and testing programs comply with all local and international testing standards. MULTI EXPANSION TAPE jointing system shall be fastened in position to give continuous network with 100 mm minimum overlaps and installed in accordance with the manufacturer’s instructions. REVISION: 3.1

The information supplied is believed to be reliable. As we do not have any control over the processing or application of the product we cannot guarantee the results to be obtained.

Users assume all risks and liability resulting from the use of this product and must confirm suitability thereof by conducting their own tests.

No guarantee is expressed or implied. Liability to the replacement of faulty material.

FOR PROFESSIONAL USE ONLY.